Casing retiring thickness


Q  - We have a 20-year old pump still in service. During a routine maintenance we
did an NDE on the casing and found that, in some sections, the metal is barely
1/32" thicker than its case retiring thickness. We also noticed in the catalogue that
some pumps have retiring thickness 1/8" smaller than its normal case thickness,
but 1/4" smaller in others.

What is the significance of the case retiring thickness? What is the true retiring
thickness of a casing? Is it time for us to retire our old pump and replace it with a
new one?


A - A casing will suffer metal loss, or loss of  thickness, due to corrosion, erosion,
abrasion, and cavitation. A case retiring thickness is the thickness at which the
casing should be retired due to significant metal loss. It means that the remaining
case metal thickness is marginally good for its design pressure and temperature.
The continuous use of the pump can result in catastrophic failure if there would be
further loss of metal in the casing.

The casing thickness takes into account factors such as its maximum design
pressure and temperature, and casing material. Based on these factors the
casing minimum thickness is calculated and a corrosion allowance is added,
typically1/8", as mandated by an applicable standard, like ASME, API, etc.

But the casing may be thicker than that because additional thickness may be
added for various reasons, such as:

  • to accommodate a different volute pattern, for pattern change flexibility
  • to accommodate bosses for fittings and instrumentations
  • to minimize large variations in casing thickness to avoid the potential for
    casting deformation due to uneven rate of cooling

In this instance, more amount of metal loss can be tolerated before a casing  
reaches its real retiring thickness. Similarly, if a pump operates well below its
design pressure and temperature, or if the casing is made of high strength
material, then a smaller case retiring thickness may become acceptable. But do
not make that decision - check with the pump vendor.

When a casing reached its real retiring thickness it is not always necessary to
replace the entire pump. Change the casing only to avoid making changes to the
baseplate and piping which can be very expensive, unless there is a compelling
reasons to change the entire pump such as its being inefficient, or having short
MTBF..

If the casing appeared to be losing its metal thickness prematurely consider the
feasibility of coating or overlaying the casing, or changing to a different casing
metallurgy that is more resistant to corrosion, erosion, abrasion, or cavitation.
CENTRIFUGAL-PUMP.ORG
TECHNICAL

Concepts

Parts

Auxiliaries

Glossary

Engineering data

Library

Bulletin board




Go to our Sitemap
for list of articles



By accessing this site
you agree to our
Terms of Use and
Legal Disclaimer



Copyright notice
Privacy policy
Custom Search